Weather-station

Weather-station

This is part II of the weather station. Part I shows the LaTeX code for the scales. Part III talks about the arduino code.

This the step by step build-up.

You need to get at teabag containment, I got a wooden one, which has four compartments. I used thin plywood and screws to build the holdings for the scales.

Preassembly

Pre-assembly

Take out the separators and cut off a small portion on the lower end to give way for the cables. The pre-assambly shows the all the electronics already connected and ready to put in place.

The separators waiting for deployment

The separators waiting for deploymen

Getting the electronics in place and get ready for the cableing.

Electronics in place, scales still outside

Electronics in place, scales still outside

Next step put the scales into place and close the lid. Done.

Weather-station complete

Weather-station complete